Rorke Data The Galaxy 65 Spezifikationen PDF herunterladen (Seite 73)

Chapter 5: Subsystem Maintenance and Upgrading

Replacing or Upgrading Memory Modules

5-7

Step 2. Remove the previously installed DIMM module from the DIMM

socket. To do this, push the white clips on either side of the DIMM

module down. By doing this, the previously installed modules will be

ejected from the DIMM socket. (See Figure 5-2)

Figure 5-2: Push Back the White Clips on the Sides of the DIMM Module

Step 3. Gently retrieve the DIMM module out of the DIMM socket. (See

Figure 5-2)

Step 4. Insert the DIMM module into the DIMM socket. Align the DIMM

module with the DIMM socket. Once aligned, gently push the DIMM

module into the socket. The white clips on the sides of the socket will

close automatically and secure the DIMM module into the socket.

Step 5. Reinstall the controller module. After the DIMM module has been

properly installed, the controller module must be reinstalled. Align the

controller module with the controller module bay. Then gently push

the controller module in the controller bay. Carefully push the

controller until you feel the contact when the board edge connectors

are mated to the backplane. Do not use force. If unusual contact

resistance is felt, try it again. Next secure the controller module into

the subsystem by fastening the hand screws on the sides.

NOTE:

When replacing a DIMM, the whole subsystem needs to be powered down.

Therefore, when replacing a DIMM, you should carefully select the time when the

replacement will be made in order to minimize the overall disruption to service.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 99 100

Keine Kommentare

Rorke Data The Galaxy 65 Spezifikationen Seite 73