Rorke Data The Galaxy 65 Spezifikationen Seite 33

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 100
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 32
Chapter 2: Hardware Installation
General Installation Procedure
2-5
2.4 General Installation Procedure
Following all the instructions provided below can save installation time. Detailed,
illustrated instructions for each component are given in the following sections.
CAUTION!
To ensure that your system is correctly installed, please follow the steps outlined
below. If you follow these steps, installation will be fast and efficient. If you do
not follow these steps, you may have incorrectly installed the hardware.
Step 1. Unpack. Unpack the subsystem and make sure that all the required
subsystem components have indeed arrived. (See Section 0)
Step 2. Install an optional BBU: a battery backup unit is highly recommended
for its protection to data integrity. It should be installed prior to
operating the subsystem. (See Section 2.8)
Step 3. Rack/Cabinet installation. If the subsystem is going to be installed in a
rack or a cabinet, it should be installed prior to the installation of the
hard drives. Installing the subsystem into a rack or cabinet requires at
least two people.
Step 4. Install hard drives. Your hard drives have been pre-integrated into
drive trays. Replacement or separately purchased SATA hard drives
must be individually installed into the drive trays. (See Section 2.9)
Step 6. Install drive trays. After the hard drives have been installed into the
drive trays, the drive trays must be installed into the enclosure itself.
Step 7. Connect the cables. Use the supplied power cables to connect the
subsystem to main power. Use separately purchased FC cables and SFP
transceivers to connect the host ports to the Fibre Channel network or
host computers. (See Chapter 4)
Step 8. Power up. Once all of the components have been properly installed and
all the cables properly connected, the subsystem can be powered up and
the RAID array configured. (See Chapter 4)
Seitenansicht 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare