Rorke Data The Galaxy 65 Spezifikationen PDF herunterladen (Seite 71)

Chapter 5: Subsystem Maintenance and Upgrading

Replacing or Upgrading Memory Modules

5-5

5.2.4 Replacing the Controller Module

If the controller module has failed, it must be replaced. To replace a failed controller

module:

Step 1. Remove the failed controller module. (See Section 5.2.3)

Step 2. Install a DIMM module on the new controller module. (See Section

5.3)

Step 3. Insert the replacement controller. Align the controller module with

the module bay at the rear of the subsystem. Gently slide the

controller module in.

Step 4. Fastening the hand screws. Once fully inserted secure the controller

module to the subsystem by fastening the two hand screws on both

sides of the module.

Step 5. Re-attach all the cables that were removed. These include the cables

that connect to the hosts, the Ethernet cable that was previously

attached to the LAN port, and the cable that was attached to the RS-

232C audio jack connector.

Step 6. Power on: Once the new controller module has been properly

installed and the cables have been correctly connected, turn the

subsystem power on.

5.3. Replacing or Upgrading Memory Modules

5.3.1 Memory Module Installation Overview

The subsystem comes with a pre-installed 256MB (or above) DDR RAM DIMM module

on the controller. The controller supports a memory module up to 2GB in size. If DDR

RAM DIMM modules with a different size need to be used or the original memory

module is damaged in some way, the pre-installed modules must be removed and the new

ones installed. Replacement and installation instructions are described fully below.

The DIMM module is located on the controller board. The controller board is a sensitive

component and must be treated with care to avoid being damaged.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 99 100

Keine Kommentare

Rorke Data The Galaxy 65 Spezifikationen Seite 71