
Galaxy Web GUI User Reference Manual
2-12 Operating without Spare Drives
If a spare drive exists in the same logical drive, the controller will
automatically mount the spare drive and start rebuilding data in the
background.
Depending on system design, it may be possible to remove a defective
drive and replace it with a new drive without shutting down the system
(hot-swapping). All HDX subsystems support drive hot-swapping.
The replacement drive must then be assigned as a new spare drive.
2.8. Operating without Spare Drives
The following are guidelines for disk failure recovery when a spare drive is not
available:
Depending on the design of the system, it may be possible to remove a
defective drive and replace it with a new drive without shutting down the
system (hot-swapping). All HDX subsystems support drive hot-swapping.
If the replacement drive is installed on the same channel and ID (the
original drive slot where the faulty drive was), you can then proceed with
data rebuilding.
If the replacement drive is installed on a different channel or ID (different
drive slot) or the periodic drive scan function has been disabled, you need
to scan in the new drive first, and then assign it as a spare drive of the
logical drive which had a drive failure. Data rebuilding will have to be
manually initiated.
IMPORTANT!
Although the RAID system provides uninterrupted disk access even after
a disk failure, do not leave a failed drive
replacement, the system will not survive a second physical drive failure on
the same logical drive (RAID3 and 5). A defective drive must be promptly
replaced and data rebuilt.
CAUTION!
When performing hot-swapping, be sure to remove only the defective
drive. Removing the wrong drive will result in complete, irrecoverable data
loss (RAID3 or RAID5). Use the Enclosure View window or Logical Drive
Information window to locate exactly which physical drive has failed.
Kommentare zu diesen Handbüchern